                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


http://www.thingiverse.com/thing:1530768
Traction Engine by cabbageheart is licensed under the Creative Commons - Attribution - Non-Commercial license.
http://creativecommons.org/licenses/by-nc/3.0/

# Summary

Traction Engine Model for  (optional radio control).
This model was designed from the ground up with radio control in mind.
It all goes together very nicely, but there are quite a lot of printed parts.
Some hardware items will also be needed, see the assembly guide for more details.
The driver figure and imitation coal are not included, I just added them to my model.

Why not show your friends and family what you and your printer can do.
The part files have all been orientated ready for printing and should fit OK on just
about any printer bed.
I did not need to use support material for any of the parts using good quality PLA.  
I have uploaded a video of this thing in action on YouTube https://youtu.be/hZ3H24cycfk
There is also a travellers wagon to go with this model, http://www.thingiverse.com/thing:1801211 .
Why not make some add on parts yourself and share them with us.
Most importent of all HAVE FUN.   


# Print Settings

Printer Brand: RepRap
Printer: Home Made
Rafts: No
Supports: No
Resolution: 0.2
Infill: 25%

Notes: 
The only part that may need support is the rear flange, my printer only just managed without.

# How I Designed This

I used FreeCad to design this thing, its got a few bugs but as you can see it does the job.