                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


https://www.thingiverse.com/thing:1738724
Treasure Chest Remix by Hvmhvm is licensed under the Creative Commons - Attribution license.
http://creativecommons.org/licenses/by/3.0/

# Summary

Remixed the 'Treasure Chest' by cushwa with the hinges of the 'Hinged Treasure Chest with Latch' by cymon. Also scaled it 2.5 times to fit the bounty of a treasure hunt I printed it for.

Correction: apparently the chest was uploaded the wrong size (2.5 times too small). I uploaded a 'correct_size' version now as well.

The hinges were designed so you could leave the lid open in an upright position, as is shown in the third photograph. This means however that the lid doesn't open further than this.

# Print Settings

Printer: Cubicon Single
Rafts: No
Supports: No
Resolution: 0.3 mm layer height
Infill: 15% infill

Notes: 
The chest and the lid were printed in Polymaker Polywood without supports. The resulting imperfections give it the old wheathered look I was after.

The padlock was printed at 0.15 mm layer height in black Cubicon ABS.

# How I Designed This

Remixed in MeshMixer.